Baumfolder Baumcut Programmable 26.4 Manual do Utilizador descarregar pdf (Página 97)

K7 - 3

Start - Up Breakdown: Scan Reference Point/Auxiliary Mode

Malfunction: After machine has been started, display shows

"SCAN REFERENCE POINT"

Cause: Machine was shut off during backgauge movement

Remedy: Scan reference point

1. Select "(1) Reference position scan"

< prompt appears: clear the table >

2. Select "(1) Confirm when table empty"

< prompt appears: go to reference position >

3. Activate electronic handwheel

< backgauge moves to reference point >

Reference run can be interrupted by pressing key

If reference point is found:

< menu display "Correction of basic position" >

4. Check basic position and confirm (see page K5B - 7)

< program data display appears >

Auxiliary mode

If the reference point scanning fails:

1. Turn machine off and on again < menu "Scan reference position"

appears >

2. Select "Auxiliary Mode"

3. Select machine type; confirm with

Machine functions possible in Auxiliary Mode:

• cutting

• backgauge movement with handwheel or backgauge movement keys

7.0 Malfunctions/Breakdowns

after turning off the machine:

if reference point scanning fails:

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 103 104

Sem comentários

Baumfolder Baumcut Programmable 26.4 Manual do Utilizador Página 97