Baumfolder BAUM15: Pile Folder 1st Station (from 2005 on) Manual do Utilizador descarregar pdf (Página 22)

TP10290-2 PAGE 22

5.3 Batch Output Time

This parameter, accessible in the Batch Setup mode,

specifies the output duration or delay that will be used when

the Batch Count Down reaches zero.

Available ranges are determined by the Batch Output Type

selected. The Table below shows the ranges for each output

type.

5.4 Sheet Length

This parameter, accessible in the Batch Setup mode,

specifies the length of the paper that will be fed into the

machine.

Available range is 6.0” to 59.0”. 6.0” is the default

selection.

5.5 Gap Length

This parameter is accessible in Run mode and Learn

mode and specifies the length of gap to use between sheets

of paper that are fed into the machine.

Available range is 0.2” to 98.0”. 2.0” is the default selec-

tion.

5.6 Suction Length

This parameter is accessible in Run mode and Learn

mode andspecifies the suction length used on a sheet of

paper that is fed into the machine.

Available range is 5% to 50% in 5% increments. 30% is the

default.

Output Delay Duration

Type Min. Time Max. Time Min. Time Max. Time

Feed Not applicable 0.0 Sec. 9.9 Sec.

Table 0.000 Sec. 1.000 Sec. 100 ms

Delivery 0.000 Sec. 1.000 Sec. 25 ms

Speed Not applicable 0.00 Sec. 5.55 Sec.

Table 15. Output Delay and Duration

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 49 50

Sem comentários

Baumfolder BAUM15: Pile Folder 1st Station (from 2005 on) Manual do Utilizador Página 22